software

i jusr bought my second set (god, i love this product) i bought the shredders used and from pics (they haven't arrived yet) looks like allan screws on them are a bit rusty on the tops..

my questions are:

any issue with taking those screws out to clean? does it matter if i have take them out one at a time and put back in or not? i haven't taken PUP apart before so i'm worried about it falling apart somehow in my hands with spools and a bunch of loose wire

to clean, im just thinking wd-40 soak and light wet sand to polish the headsup, if necessary.

finally, if any screws are stripped, do you think they are just standard allan screws you could buy at a hardware store?

and really finally, i'm a newb here, but i've read a lot of threads and looks like a good helpful bunch of passionate people!'

thanks

When I want to clean them, I take them out, which is no problem because they are threaded into the bobbin and don't actually hold anything together. Then I sand Blast them and put them through a blackening solution and an oil bath and leave them to sit for a couple of days. They look like new when I'm finished.

I don't have any pics of any I've done, as they've been for friends. I may do some of my own this week...

I offer this as a service for a small fee. PM me if you're interested.

Trevor

thanks for the quick reply pinto..i may take you up on that..can't wait for them to get in my hands!

actually, sent you a pm