close
Several modifications are required to both the LEAD and RYTHYM circuits, as follows:
NOTES FOLLOW SEYMOUR DUNCAN SCHEMATIC PAGE
BOTH CIRCUITS:
Add a Treble Bleed modification to the volume pot (Simple 100K resistor and a 0.002 mfd capacitor soldered arcoss the hot inlets and hot outlets of each circuit volume pot - add this resistor/capacitor combination between the yellow and gray wires.)
RYTHYM CIRCUIT ONLY:
Add a 200K resistor on 50K linear tone circuit (Simple - add this resistor between the green and gray wires.) This increases your resistance and brings the tone to a better rythym range then was possible with the standard setup.
NOTES FOLLOW SEYMOUR DUNCAN SCHEMATIC PAGE
BOTH CIRCUITS:
Add a Treble Bleed modification to the volume pot (Simple 100K resistor and a 0.002 mfd capacitor soldered arcoss the hot inlets and hot outlets of each circuit volume pot - add this resistor/capacitor combination between the yellow and gray wires.)
RYTHYM CIRCUIT ONLY:
Add a 200K resistor on 50K linear tone circuit (Simple - add this resistor between the green and gray wires.) This increases your resistance and brings the tone to a better rythym range then was possible with the standard setup.
全站熱搜
留言列表
