software

Hey guys, I worked on this, there aren't alot of mistakes (basically only a couple of wrong notes). I did my best on this one, hope it sounds better than all of my covers...please listen to this and rate/crticize. Thanks in advance.
Well heres the link:

a friend asked for my advice on what this pups is..

I thought I'd try and offer this stuff for trade. I have a Boss GT-6 that is nice and clean and ready for anything you can dish out. It comes with the manual, patch list and power supply. It's $250 shipped or for trade I'm looking for an amp or whatever you may have to trade.

nevermind.

I´ve got a line on a Boss SE-50 9.5quot; effects unit, would fit perfectly next to my wireless.

Im thinking of getting a new guitar with the money im saving from my summer job. My uncle said that his friend has a Godin and he says he loves it. I Looked at their website and the Freeway SA ooks like my kind of guitar. Has anyone had any experience with godin and could you tell me about their guitars?

2 Weber beam blockers 10/10 condition $25shipped in U.S.

Theoide came by today and he installed Phat Cats in my Washburn hollowbody. Man this is truly amazing sounding guitar.
Have you felt that humbuckers don't have the enough character and dynamic? Have you felt singlecoils sound too thin and ice-picky? If so, please try phat cat. Also, if you have hollowbody and want to cover blues to classic rock, you should try phat cat.

Can anyone give me any input on what a Lil 59 for Teles sound like when you split the coils? Is it really even worth doing? I have an American Nashville B Bender Tele and I have already installed the 59 and I have the parts to go ahead and wire it for coil taps. Would you do it? Also the pots I have are both 500k will this affect the tone much?

I recently installed a 59 in the neck position to join the 59/CC I have placed in the bridge. Well, I can't get a sound from the neck position, nor the blended position. The bridge position was fine. Normally, if the neck pickup is disconnected, or not placed, the 2nd position blend still works, being the same as position 1. There is a wire that is connected to position 2, which is the blend position, that connects to the volume pot ground. If this is not connected, no sound comes out, regardless of to the number of pickups. Everything appeared to be connected, no wires touching. The only thing is this. When I installed the 59, I had stripped the mesh wire (2 conductor) and soldered part of the bare wire to the ground. Then connected the tip of the bare wire to position 3. Is the mesh wire suppose to be grounded? Or is it just the bare wire? Thanks in advanced.