software

I am looking to buy one of these, what do people think of them?

I'm interested in what you all are using...

Alright, my understanding is to replace all the 250k pots with 500k pots (3) and wire everything exactly the same, and where the lead went from the stock bridge single coil, solder the black from the duncan JB there, tape off the red and white wires, and ground the green and bare to the volume pot correct? And, do I leave the capicitor on the bottom tone pot since I switched to 500k pots or remove that and solder a wire from the post it was on to the bottom of the tone pot?

OK, well, I just sold my hot rails neck pickup to vinterland, and now i'm lookin for a new neck pickup for my EBMM, specifically the little 59 or the cool rails.

Can anyone help me figure out how to wire a guitar with the signal going through the Tone pot and then the Vol?

I was looking at this amp online, and my main question was quot;can it do cleans?quot; I like Dumble-ish drive tones a lot, but I always love an amp to have a decent clean. That's my question to anyone who's played one. Thanks!

and it is a killer fuzz! Fantastic bang for the buck IMO.
i was just looking at that... i kinda wanted to get it but is it only good for 60's rock like it says or what? tell us some more about it

what do you guys think about cabs for gigging ? which ones would be good enough for 100-200 people ? and what are cons / pros of a Cab vs PA system ?

As the title reads... Marshall FINALLY got their homepage updated, it's about time I think.

Hey Guys.