software

clicky here-gt; from : localhost/www.privatereserveguitars.com/?src=mf

What's the best Fender Telecaster in terms of tone (not from the pickups, I mean the natural tone) and playability that has a satin finished neck and either the standard two single coils or single coil bridge and humbucker neck?

I need to raise the action just a hair on a guitar to eliminate some fretting out on the guitar. (until I can afford a fret leveling.) Whats the best way to do that? Tighten the spring claw??

I've been debating for a while now whether to get a Floyd Rose and I was just wondering if someone could tell me the good and bad points of them? Thanks for any help.

I'm thinking it will, but it'll be a non reversable mod, so I wanna make sure.

Not REALLY vintage but vintage style...chrome with slots so you have to cut the string and put it into a hole in between the slots, rather than just stringing it thru a hole.

I have read a really good reveiw about this. Total guitar gave this a rave review and reckon its by far the best recording modelling tool they have ever heard.

Alright, I'm fixing my singers Epiphone 335 copy. The problem was no out put. Pulled the guts out and the leads to the output jack had broken off. Easy enough, resodered it, and before stuffing the guts in, tested it through an amp. No dice. Resodered figuring cold joints, no dice. Did it again, and agian. No dice. The amp is good. I broke out a multimeter and I am finding the pickup resistanses from the jack, so the sodering should be good.

I'm looking for clips of the DD and the Full Shred BRIDGE pickups... should be quite High Gain ... something Metal or so

All,
Today I got the pickups installed with a friend of mine: JB/Jazz combo. However, for some reason, I'm having height adjust problems. I'm in my room, none of my friends have a ruler. I want to adjust the height of the pickups because the chord work sounds a little muddy (plugged straight into 1972 fender twin reverb). Also, the high E with the JB only sounds almost nonexistent. I'm thinking adjust height before adjusting pole piece screws. Anyone that can help me figure it out without a ruler would be greatly appreciated! lol Thanks