software

I'm looking for a used/cheaper seafoam green hardtail strat or tele body. Let me know.

black CC trembucker. it has some light scratches on it but not horrible. witth he flash of the camera in the 2nd pic it makes them look worse then they are. tons of wire left (never cut, only stripped back) perfect working order.

I was checking out a Ibanez Arstar from about 97. It is in beautiful shape but I don't know a lot about them. He wants $375 with HSC. It plays very nice and has no nicks, scratches, I mean a 10 out of 10.
Does anyone know some pro's or con's about these guitars. I noticed the neck pocket did not look real snug and it uses a 3 bolt neck.

Hey,
Has anyone used the Groove Tubes KT66-HP in a 6L6GC amp? Has it worked okay? I'm looking at getting a pair of KT66's for my Hot Rod Deluxe. However, 6L6GC's only require 0.9A heater current, while KT-66's require 1.3A Ih. According to Justin Holton (of the Unofficial Hot Rod Deluxe Owner's Guide):

Post any shredders you can list. It has to be budget, and have mojo (though that's subjective...), be very 80s Of course brands like Kramer, Jackson and Charvel are a bit obvious

We all know the wah-wah sound of a crying baby, but is there a wah-wah pedal that sounds like a cat? This is a serious question!

I have a 7-string ESP, Stephen carpenter signature model and am not real happy with the default EMG 81-7 active pickups and electronics. I am new to the whole quot;switchin' outquot; pickups game, and was wondering if anyone had any suggestions (hardware-wise) on how I could tighten up the low B string for better clarity. I really wanna enhance my mids and highs for better sustain and harmonic response. Right now, the silencing effect of the EMG's seems to block out any quot;organicquot; feel, it's almost mechanical-like. I was also wondering how I could go about getting a coil tap installed onto the guitar and how much that would cost me. Thanks for any help anyone could give me.

I'm interested in getting the STC-3a tone control circuit along with the AJB-5 pups. My bass is a 3 control config but the only wiring diagram for the STC-3 is for a four control config. I would rather not alter my bass, is there an alternative wiring scheme available for this preamp?

So a few days ago I did a pickup swap on one of my Japanese Les Paul clones. The guitar had always been decently bright sounding and had good tones, but I felt it was just missing something I couldn't put my finger on.

I need a 1 MEG pot that will fit properly to replace a 5150 lead channel post volume/gain.