I've been woking on putting this thing back together. Found a schematic
got the right tubes in it. It fire's up now but has a loud humming. So it's
- Mar 19 Fri 2010 20:57
Premier 90 reverb tank restoration project
- Mar 19 Fri 2010 20:57
GAS Fender Twin in Blonde!!!!
I've always had a weakness for Fender amps.... I don't even really enjoy their sound as much as i love the way they look... I like to play thru them with pedals for my distortion.. but man the local store has a new Twin covered in a light Blonde covering.... HOLY!!!!! man has anyone else seen these!!!!!?
- Mar 19 Fri 2010 20:57
Tune quot;Play the gamequot;
It´s me again!
- Mar 19 Fri 2010 20:57
..looking for some pretty cool older amps?
We're selling off a few really nice amps on flea-bay..... just a heads up!
- Mar 19 Fri 2010 20:57
Can someone fill me in on Hot for Strat Livewire Single Coils?
I'm thinking about buying these, but would they suit my style? I do play lots of clean stuff, but I like the occasional distortion. Musicians I like (and play) are the Red Hot Chili Peppers, Stevie Ray Vaughan, Jimi Hendrix... So lots of blues and clean stuff. Would the Hot Livewires suit my need? Or how about Classic Livewires? Let's keep this discussion on active pickups for now (by which I mean I don't want any quot;Livewires suck! Get this or that!quot; discussions. At least not right away )...
- Mar 19 Fri 2010 20:57
a pickup wiring question
well i was going to go with a set of ZW EMG's but it appears im not gonna have the room inside the guitar that i need for this. so im going with passive pickups instead...however i would like a very versatile guitar as far as sounds go, i plan to play hardcore / metalcore / punkrock about 50% of the time so i would like a really great but not too dirty sounding distortion, i also would like to have stuff for blues and jazz so id like really great clarity also. i plan on playing lead guitar, the guitar will be made out of maple/mahogany and an ebony 24 fret fingerboard. i would like really great highs / mids / harmonics and id be willing to sacrifice a little bit of bass for them...however i dont want my guitar to come off as glassy or brittle. im thinking about doing a 3-way blade switch two volume / two tone wiring with push pull pots for dual coil tap and reverse phase switches wiring that i saw on i read the board quite often and it just seems that every time i finally have my head set on a pair of pickups i read about how another one or two are so much greater and its killing me trying to pick some out. would you guys have any suggestions for this type of guitar ? im very open minded about pickups and though i would LIKE to use seymour duncans id be willing to use other types if it will help me achieve the tone(s) im looking for..also if there is a better / more complex wiring scheme that i could use to help me get as many tones as possible i would be really greatful to have it. thanks in advance
- Mar 19 Fri 2010 20:57
Pots for Phat Cats?
- Mar 19 Fri 2010 20:57
Duncan and Fender TS
Hi, I´m new at this forum. I´m from Buenos Aires, Argentina. I have a ´62 reissue strat loaded with a set of Texas Special that works well for me but I´m looking for a thicker sound in the bridge position, for crunchy chords and hot leads. I´ve tried a Coll Rails, It sounded good but I want a real single coil because I don´t want to lose too much high end (and I don´t like how they look in a vintage strat also). What is the next step down ? I´ve thinking in the SSL-3 or SSL-5 what do you think of this pickups ?
- Mar 19 Fri 2010 20:57
Atomic Reactor Modeling amp thingy?
Who has played/owned one of these?
- Mar 19 Fri 2010 20:57
EVH D-Tuna on Ibanez Edge Tremolo?
Is it possible to install an EVH D-Tuna (tunes E down to D w/ a twist) on an Ibanez Edge Tremolo III?

