software

For this split diagam is the bucker split when the switch is down towards the soldered lugs or up towards the empty lugs? I just wanna make sure which way to install the switch.In this diagram, the Bucker would be split when the switch is down...
It is so because when the switch is down, the two lower lugs are connected to each other and one coil is sent to ground.

I am interested in replacing the stock pickups in my Stat. The details are as follows:

It's actually a push/push pot, but I was wondering if anybody here used/uses one. I just put one in my Strat with a tapped bridge pickup, the tap is fine but the pot is the tone control and it seems to have a very strange taper...from 10to about 3 it seems to have almost no effect then from 3 to 0 it gets very fat very fast! Anybody else have this quot;problemquot;?

I have a like new (10 hours) swamp thang 8 ohms. I am looking to trade it for a g12h30 or hellatone 30. I am also interested in a v30 or hellatone 60. I want to see how they sound compared to my eminence governors and wizards. If I like them I could be selling one of my wizards or 1 of my governors so I can mix eminence and celestion models in one cab. Let me know people. Thanks

Yep.....Like It And You Will Too!

Hey,

Okay, I'm getting an itchy trigger finger. Time to build a new amp or mod one that I have. Gotta start flirtin' with those dangerous electrons again...

I can't decide between some EMG-81s or JB and Jazz. All of your opinions would be useful. I have only played on each kind of pickup once and I did notice quite a difference between the two. I know EMG-81s have more output and all. I've always been a fan of the Megadeth sound and Mustaine used Duncans. On the contrary I've heard EMG-81s are more versatile than Duncans. I would like it do be able to do more than just heavy metal. The Dinky has EMG-HZ pickups in it right now which of course aren't bad I just need to get a little better sound for recording coming up in a few months. I play alot of metal but also alot of hard-rock stuff like Satriani and Van Halen. So which ones would some of you guys pick? Thanks.

Anyone out there have, or have the ability, to cut a bone nut for a 57' RI Goldtop? I have one inbound (pic below) and it will need a new nut right away. I use 9-46 strings on my LP's. I will of course pay for the nut and labor if anyone can provide. I just need something to get me buy until I can schedule a time for Splawn Guitars to take my new baby in and give the nut a proper dressing, and do the rest of a good initial setup.
Consider it done.

i have a zebra jb for bridge and may want to put a jazz neck in that's black on both plates right now..but i have a creme plate i could put on to match to match..before i get into a whole bunch of trouble, is it as simple as undoing the screws and swapping plates?