software

Which would you choose for a boutique amp?

Okay ive been using my line6 dl4 delay stompbox for a while now since i got it and its been pretty good but i never really sat down and stuffed around with it too much, i just got a couple of delays and went with them...but now im not sure if they're as good as i could have them.

...and I LOVE it!!!! Its like brown sugar its dark and sweet. the mids are so smooth and the low notes just moan so sweetly and the high notes are just trebly enough but not overbearing (like my sh13 cleans). The dime in the bridge compliments it awesomely and gives it a nice mix of both worlds. I LOVE THIS PICKUP IN THE NECK. Am I the first to use this combo?

Short and simple, do these exist?

can you put them side by side and see how much bigger the hellraiser is?

i did another random jam and posted it on sound click... the download hasn't cleared yet, but the lo-fi link works... from : localhost/streamer.soundclick.com/jerry... randomjam.mp3 Done with an epi les paul with a DiMarzio super distortion through a marshall mg50dfx... It was miced with a piss poor computer microphone, which explains the terrible quality... the microphone doesn't do the tone any justice.

Pristine Clean: My gear stays in glass cases on my wall and are never/rarely played.

a cheap- good quality randy rhoads v shaped guitar that will last me for a good amount of time

Well ai have a Quiestion about wiring, I have a sh-6 bridge humbucker and a classic live wire single on the middle pos also and paf Joe on the neck, an a 5 way switch, i want to hace the original 5 factory sounds, but aldo the following bridge series/spli/parrallel/ phase
neck on

Alright, I have a strat with hotrails in the bridge, I absolutely love this pickup. It's got bite, edge, insane gain, everything I want. I recently bought a Gibson Flying V, and I love everything about the guitar except the pickups. They just arent as hot as I'd like. I was wondering if I could fit two hotrails in the bridge pickup slot and wire the guitar as so: bottom position is just the bottom hotrail, middle position is both hotrails in the bridge slot, and top position is the neck pickup. I think the two hotrails going full on at the same time would be nuts and hotter than if they were in seperate slots. Is this possible?