software

what am i doing if i wire up a 4 conducter with the black and bare wires together, soldered on the volume pot, and the white wire on the side of the pot with another wire going to the switch and the red and green together, i did this and it works fine, but the pup sounds a little weak, have i wired only one coil or something? lol thanks

Ok guys...I am looking for a new amp and while I have a lot of ideas for what I am looking for I though I'd do it like this...I gonna list specs and see what you guys think of!

All of you rectoverb owners might be able to identify with this... The multi-pin cable that connects my rectoverb's 3-button footswitch to the multi-pin jack on the back of the head doesn't attach itself very strongly to the footswitch. It's ALWAYS falling out and doesn't seem to want to stick in there, yannow?

Just wondering cos i found one on ebay:

ok, so i read in reranch that after you do your clear coats and wait a few days you can go ahead and start to polish the finish using higher grades of wet paper.

Hey guys, I was at band practice tonight and I got thinking I might want to look into a POD or similar modeller. It should have good sounding amp models that can go from sparkly clean to all out metal, maybe a few effects, and be a great recording tool. I'm guessing the PODxt is a good start? Any other suggestions? Oh and state price if you can.

Hi,

Hey pals! Long time no talk huh?!

Well, I FINALLY got it in... My Lil 59 was in the maiilbox waiting on me... I drove to the nearest city with music stores (1hr drive) and only one of them had a 500K Push-Pull pot.... At any rate, I have the operating room prepared, and the iron is HOT... But I have a few questions.....

from : localhost/cgi.ebay.com/ws/eBayISAPI.dll...tem=7308222534