software

Title say more or less everything, I may need a power supply for my Microverb III pending answer from the eBay seller I got it off of.... I think PS-3 or PB-3 or something is the number, the oone with the barrel plug.

Can anyone tell me the differences between X2N and superdistortion?
I want to replace the tone zone in my RG3120 with either of them. I found that tone zone easily gets muddy. The guitar is made of mahagony with rosewood finger board, and it has a dimarzio paf in the neck, which I am satisfied with. Basically I want the bridge pup provide clarity under hi gain, and sound tight and bright. Which is better, X2n or Super Distortion? Thanks

How would a 59n sound different then a SLn in a Les Paul style guitar using a high gain amp (i.e Mesa Boogie Rectoverb). FYI, I have a 59b and I really love the sound of the 59b. I Like the sound of the SLn too, but curious about a 59n.

Hey dudes. I have a Reverend Slingshot Custom guitar with P-90s. The guitar is a semi-hollow bolt on with a mahogany block in the middle, with phenolic top and back. I love the axe, and for the amount I use them, the neck and middle pickups are cool. I don't really like the Bridge pickup all that much though. I find that it lacks balls and growl, and tends to be a little on the nasal and abrasive side when overdriven, although it does have a nice clean tone. The bridge pickup is wound to 8.5k, according to the sticker on the back. I'm actually looking for something that sounds a bit more like the Phat Cat pickup, which is nice and growly and ballsy, but not all that hot. I basically just want to play classic rock and blues with this guitar.

$375... including the pedal and manual.

HEY ALL of you out there who've used a Carvin Nomad

Hi,
I got this schematic, but I forgot whom! I just had a quick question if anybody could help me out. I have a 250k push pull pot. I have everything soldered, except to the push pull part. My question is this based off of this schematic: Is this wiring for the push/pull from the top view or the bottom view? All of the pots in the picture are bottom up (hope that makes sense), so I didn't know if that meant that the push/pull was to be wired in this fashion. I don't know if I should have it wired upside down or rightside up. Help!?

My amp is designed for 4 ohms and my cabinet for 8 ohms and i think I'm killing my amp by running it into a missmatched cab. Is there any way to rewire the speakers to make it 4 ohms, or should i get a different cabinet?

Perfect condition, 3 inch and 4 inch wires for black and white, respectively.

Hey Guys