software

I want to set up my Schecter with 2 humbuckers, 1 volume, 1 tone and a 3 way switch. I'd like to put a push/pull on the tone control for a coil tap to split each humbucker to single coil. I'm a little confused on which schematic to follow in the wiring diagram setup. Can anyone advise. Thanks.

Hi MrWolf; Welcome to the forum.

Use this diagram with a couple of simple quot;modsquot;.

from : localhost//website...y-w-split.html

I would connect the quot;groundquot; to the top lug, instead of the bottom lug, so the coils are split when you quot;pullquot; the knob.

Also, duplicate the red/white wires for the other pickup on the quot;mirrorquot; side of the switch. That is, the opposite side, exactly like the other side. That will split both pups.

If you're still not sure, let me know. I'll make you a custom diagram.

Artie