software

Hallo to all,
I'm not a very guitar technician expert but I would want to repair my old guitar with your assistant (if possible...)

On the schematics page I haven't found a scheme for the setting of my guitar.
I have:
2 pickups (single coil)
1 volume pot
1 tone pot
2 Double pole On/On slide switch (DPDT)

On the schemes there are not indication for the connection with this configuration.
In particular I don't know wich type of connection I must do with the 2 DPDT.

Moreover, I don't know the difference between the series-parallel, series-split-parallel or phase reversal setup with the DPDT configuration.

Can you help me? If possible can you send me some schematics for my guitar setup? Or where I can find on web these schematics?

I hope that this request is not off topic...

Thanks in advance,
Mattia

welcome to the message forum

i am not sure what you want to achieve with your wiring, so i will give you general advice ...

take the hot wire from the SD bridge pickup and put it where the original bridge pickup hot wire is going now ... take the hot wire from the SD neck pickup and put it where the original neck pickup hot wire is going now ... this should result in the wiring be the same as you have it now, only with new pickups

if you tell us what you are trying to achieve with the switching, we can help with more detailed advice

good luck
t4d