software

Hello fellow guitar players; I'm new here and need a little help. I'm completely rewiring my guitar. I have the following pickups that I will be installing and need some help/suggestions for wiring it up. This will all go into a Samick Stratocaster copy.

JB Jr. into the Bridge
Vintage Rails into the Middle
Great White Snark in the neck

I will also be replacing the pots, caps, switch, and phono jack.

Any advice would be greatly appreciated. Thanks in advance.

Here you go for all your schematic needs:

from : localhost//website...hematics.shtml

I've used this one before:

from : localhost//website...l_2tone_5.html

But the wiring for the Vintage Rails and the quot;Snarkquot; seem to be different than shown for a typical single coil. I'm not sure exactly how to do it.

Hey gizmo; welcome to the forum. That diagram you have is good, just make a couple substitutions:

Vintage Rails:
White and bare to ground
Red to the switch

Unfortunately, I don't know what the color codes are on the Snark. I would assume that white would be quot;hotquot;, and black ground.

Hopefully, someone who's used them will chime in on that one.

Hey, thanks for the help. That quot;Snarkquot; pickup wiring was white, red, and bare; so i wired it up like the vintage rails. I finished all my wiring so now I'll have to set it up and test it out. Hopefully everything works.