software

Bought a single humbucker 9Custom/59) hybrid from Kaetu a while ago. It doesn't seem to have 4 leads from it like a 4 conducter pup? Where do I wire the 2 leads? Is there a wiring diagram anywhere? Also what about a Custom Custom? Is there a wiring diagram for one of these?

Thanks

For your hybrid follow this diagram:
from : localhost//website...tics/humb.html
The braid gets soldered to the back of the volume pot.

For the Custom Custom follow this diagram:
from : localhost//website...1hum_1vol.html
Black = hot
Green and bare = ground
Red and white = solder together and cover with tape

Granted these may not match your entire wiring scheme but you'll see what wires go where.

Many Thanks M8!!


Originally Posted by ErikHFor your hybrid follow this diagram:
from : localhost//website...tics/humb.html
The braid gets soldered to the back of the volume pot.

For the Custom Custom follow this diagram:
from : localhost//website...1hum_1vol.html
Black = hot
Green and bare = ground
Red and white = solder together and cover with tape

Granted these may not match your entire wiring scheme but you'll see what wires go where.

The first link shows a diagram of a neck and bridge hum being wired to a volume and tone? I need a diagram for a single hum which is a Custom/59 hybrid cionnected to a volume pot. The second link will work for the custom custom, but I need a similar diagram for the hybrid pup which has fewer wires from it - I think it has just one wire in braid?

I want to make sure I'm clear - are we talking about two different guitars, each with a single humbucker?

If so, just use the second link, but ignore the red and white wires, (since you don't have them.) Your outside braid goes to any ground - like the back of a pot, and the inner wire goes to where the black wire in that diagram goes. (The lug of the volume control.)

Hope that helps.

Artie