software

Does anyone know where to get parts such as toggle switch caps and pup mounting rings that fit an Epi LP? I bought a GIbson toggle switch cap and it didn't fit. Thanks

-Eric.

Help him out guys, Zerb might be able to help Eric. Multiple other friends of mine BETTER help haha. Come on guys, I have an epi to and really should know where to get spare parts.


Originally Posted by SeraphimTNHelp him out guys, Zerb might be able to help Eric. Multiple other friends of mine BETTER help haha. Come on guys, I have an epi to and really should know where to get spare parts.YES SIR!

Actually...your ****ed....as you know Gibson parts wont fit and no one carries epi stuff...they quit the parts division...used to be they had a parts selection just like gibson, but no more....You just have to test every part you see and hope for the best...Ive been through it and scoured an entire major metropolitan are to no avail.

Wrong, look for a parts supplier that carries metric parts, like WD, Mighty Mite, ETC. They come from the same place for the most part.

is where I've been getting some of my stuff lately.

Of course for something like that if it's too tight to fit, I'd take a drill and widen the hole and tap it using the thread on the switch, but I'm not sure about that.

Thanks for the help!
I'll check out that site.
-Eric.

I beleive AllParts is a good source for metric parts...

Stewart MacDonald also has replacement bridges and tailpeices etc. that will fit an Epi...