software

Im looking for schematics.

Hum/Sing/Hum , 5 way switch , 1 volume , 1 push/pull tone ( so i can split humbuckers).

switch settings

1.Neck only
2.Neck/middle
3.Middle only
4.Middle/bridge
5.BridgeSo i this give me eight settings ?

btw i am only going to change the bridge pup

from : localhost//website...hematics.shtml

Here you go. Choose your setup and the schematics are there.

This one's close to what you want:

HSH 1 volume 1 tone

But in your case, you'll want to connect those red/white wires to the center lugs of your push/pull - and not to the 5-way.

Then, connect the top two terminals of the push/pull to ground. Like they show in this diagram, but you'll do both sides of the switch, and use the top terminal for ground.

splitting

do i need the green chewing gum things?

and how do i solder to ground?

Yes . . . those are the capacitors that make your tone control work. You can get them in many colors and sizes though. Different values give slithly different tone affects. The higher the number, the more highs you roll off.

Traditional guitar values are .047uf, .022, and .01uf. But you aren't limited to those either. You may just want to use whatever is in the guitar now.

quot;Groundquot; just means the negative, or quot;sleevequot; side of the output jack. Usually, the back of the pots is used, and then it is wired to the output jack.

oket , thanks