software

k well hello all. i'm new to wiring i really need help on this wiring.Can anyone HELP? It's a JB bridge humbucker, and 2 hotrails does anyone have an accurate shematic they could post i need this asap . THX

any help please help! i need this working by tomorrow afternoon

what control pot config. does it use? volume, tone, tone or other?

you can't find it here?

from : localhost//website...hematics.shtml

-Mike

its 1vol 1tone 5ws . from : localhost//website...l_1tone_5w.htm that looks like the one ,but do i wire the 2 singles like they show and just ground the green/bare and solder the red and white together.Because that diagram is just of plain singles , these are single humbuckers.Does more come into play or is that exactly as it should be done? it also shows just using one side of the 5ws and not the other is that correct?And can i tie all the green and bare wires together ; or do they need to be separate?ie. 3 different groundings... Sorry for the nubbishness :/

that diagram is perfect for you...ok, lots of questions, lets see...

-for the singles run the black wire to where they show the gray of the regular singles.

-solder and tape off the red and white together as shown (but on all 3 pickups) do not connect all red and whites together, just each pair from each pickup.

-connect the ground and the bare together and solder them to the back of the pot...yes you can connect all 6 wires (3 green, 3 bare) and ground them as one.

as for the one side of the switch thing...it's fine. if that's what duncan says, that's what works

and no problem on the questions, you have to learn somehow. good luck with the project!

-Mike

awesome man, i thought that was it , i was just skeptical , thanks